Language

中文版

English

Home page

Installation of thermal measurement instruments at the screw air compressor station

Release time:

2021-08-09

Author:

Source:

Abstract

Serial Number	Measurement Point Name	Installation
I. Temperature
1	Exhaust gas temperature of each section	Should
2	Inlet air temperature of each section	Should
3	Oil cooler outlet oil temperature	Should
4	Bearing temperature	Should
5	Cooling water inlet temperature of the main water pipe	Should
6	Unit outlet water temperature	Should
7	Aftercooler outlet water temperature	Should
II. Pressure
1	Air compressor station supply air header pressure	Should
2	Air compressor exhaust pressure	Should
3	Air compressor unit cooling water inlet (after valve) pressure	Should
4	Lubricating oil pressure (at lubrication point)	Should
III. Flow Rate
1	Air compressor unit outlet flow rate	Should
2	Air compressor station supply air header flow rate	Should
Note: The installation of measuring instruments for the air drying and purification device is the same as Table A.

Keywords:

Installation of thermal alarm signals and automatic protection control for screw air compressor stations

Drying and purification of general-purpose compressed air and sterile compressed air in breweries

Recommended Reading

Applications of low-pressure, high-volume compressed air dryers

The same warehouse transports different raw materials between different countries. In this case, warehouse cleaning becomes the most important link in ensuring that goods are not contaminated.

2021-08-09

Comparison of various suction machine performances

Different adsorption regeneration methods will have differences in drying depth, air consumption, working cycle, equipment structure, etc., each with its own characteristics.

2021-08-09

Process system

The model, quantity of air compressors, and air supply systems with different air quality and pressure should be determined based on air supply requirements, compressed air load, and technical and economic comparisons. Within the compressed air station, the number of reciprocating or screw air compressors should be 3-6 units. For air supply systems of the same quality and pressure, the number of air compressor models should not exceed two. The number of centrifugal air compressors should be 2-5 units, and the same model should be used.

2021-08-09