Language

中文版

English

Home page

Installation of thermal measurement instruments at the centrifugal air compressor station

Release time:

2021-08-09

Author:

Source:

Abstract

Serial Number	Measuring Point Name	Installation
I. Temperature
1	Inlet Air Temperature of Each Stage	Should
2	Exhaust Air Temperature of Each Stage	Should
3	Lubricating Oil Cooler Inlet Oil Temperature	Should
4	Lubricating Oil Cooler Outlet Oil Temperature	Should
5	Lubricating Oil Tank Oil Temperature	Should
6	Lubricating Oil Cooler Drainage Temperature	Should
7	Water Temperature of the Main Water Inlet Pipe at Each Level	Should
8	Cooling Water Inlet Main Pipe Water Temperature	Should
9	Speed Increaser Bearing Temperature	Should
10	Compressor Bearing Lubricating Oil Temperature	Should
11	Compressor Motor Bearing Lubricating Oil Temperature	Should
12	Compressor and Motor Support Thrust Bearing Temperature	Should
13	Compressor Motor Support Bearing Temperature	Should
14	Compressor Motor Stator Temperature	Should
II. Pressure
1	Cylinder Inlet Air Pressure of Each Stage	Should
2	Cylinder Exhaust Air Pressure of Each Stage	Should
3	Aftercooler Outlet Air Pressure	Should
4	Air Compressor Cooling Water Inlet (After Valve) Pressure	Should
5	Compressed Air Station Supply Air Main Pipe Pressure	Should
6	Lubricating Oil Pump Outlet Main Pipe Oil Pressure	Should
III. Flow Rate
1	Air Compressor Unit Outlet Flow Rate	Should
2	Compressed Air Station Supply Air Main Pipe Flow Rate	Should
IV. Others
1	Compressor Shaft Vibration	Should
2	Compressor Shaft Displacement	Should
3	Speed Increaser Shaft Vibration	Should

Keywords:

Installation of thermal alarm signals and automatic protection control for centrifugal air compressor stations

Installation of thermal alarm signals and automatic protection control for screw air compressor stations

Recommended Reading

Applications of low-pressure, high-volume compressed air dryers

The same warehouse transports different raw materials between different countries. In this case, warehouse cleaning becomes the most important link in ensuring that goods are not contaminated.

2021-08-09

Comparison of various suction machine performances

Different adsorption regeneration methods will have differences in drying depth, air consumption, working cycle, equipment structure, etc., each with its own characteristics.

2021-08-09

Process system

The model, quantity of air compressors, and air supply systems with different air quality and pressure should be determined based on air supply requirements, compressed air load, and technical and economic comparisons. Within the compressed air station, the number of reciprocating or screw air compressors should be 3-6 units. For air supply systems of the same quality and pressure, the number of air compressor models should not exceed two. The number of centrifugal air compressors should be 2-5 units, and the same model should be used.

2021-08-09