Language

中文版

English

Home page

Installation of thermal and measurement instruments at the piston air compressor station

Release time:

2021-08-09

Author:

Source:

Abstract

Serial Number	Measuring Point Name	Installation
I. Temperature
1	First-stage cylinder exhaust temperature	Should
2	Second-stage cylinder exhaust temperature	Should
3	Aftercooler exhaust temperature	Should
4	Cooling water inlet temperature of the main pipe	Should
5	Air compressor unit cooling water drain temperature	Should
6	Air compressor drive mechanism lubricating oil temperature	Should
7	Air dryer inlet temperature	Should
8	Air dryer outlet temperature	Should
9	Heater temperature of the heat regenerative adsorption air dryer	Should
10	Regenerator inlet temperature of the heat regenerative adsorption air dryer	Should
11	Regenerator outlet temperature of the heat regenerative adsorption air dryer	Should
12	Refrigerated air dryer evaporation temperature	Should
II. Pressure
1	Air compressor station air supply main pipe pressure	Should
2	First-stage cylinder exhaust pressure	Should
3	Second-stage cylinder exhaust pressure	Should
4	Air tank pressure	Should
5	Air compressor unit cooling water inlet (after valve) pressure	Should
6	Air compressor unit drive mechanism lubricating oil pressure	Should
7	Air dryer pressure difference	Should
8	Air filter pressure difference	Should
III. Flow Rate
1	Air compressor unit outlet flow rate	Should
2	Air compressor station air supply main pipe flow rate	Should

Keywords:

Installation of thermal alarm signals and automatic protection control for the piston air compressor station

Installation of thermal alarm signals and automatic protection control for centrifugal air compressor stations

Recommended Reading

Applications of low-pressure, high-volume compressed air dryers

The same warehouse transports different raw materials between different countries. In this case, warehouse cleaning becomes the most important link in ensuring that goods are not contaminated.

2021-08-09

Comparison of various suction machine performances

Different adsorption regeneration methods will have differences in drying depth, air consumption, working cycle, equipment structure, etc., each with its own characteristics.

2021-08-09

Process system

The model, quantity of air compressors, and air supply systems with different air quality and pressure should be determined based on air supply requirements, compressed air load, and technical and economic comparisons. Within the compressed air station, the number of reciprocating or screw air compressors should be 3-6 units. For air supply systems of the same quality and pressure, the number of air compressor models should not exceed two. The number of centrifugal air compressors should be 2-5 units, and the same model should be used.

2021-08-09